Defect Analysis and Detection of Cutting Regions in CFRP Machining Using AWJM
Métricas y Citas
MetadatosMostrar el registro completo del ítem
Autor/esMayuet Ares, Pedro Francisco; Girot Mata, Franck; Batista Ponce, Moisés; Salguero Gómez, Jorge
Departamento/sIngeniería Mecánica y Diseño Industrial
FuenteMaterials 2019, 12(24), 4055
The use of composite materials with a polymeric matrix, concretely carbon fiber reinforced polymer, is undergoing further development owing to the maturity reached by the forming processes and their excellent relationship in terms of specific properties. This means that they can be implemented more easily in di erent industrial sectors at a lower cost. However, when the components manufactured demand high dimensional and geometric requirements, they must be subjected to machining processes that cause damage to the material. As a result, alternative methods to conventional machining are increasingly being proposed. In this article, the abrasive waterjet machining process is proposed because of its advantages in terms of high production rates, absence of thermal damage and respect for the environment. In this way, it was possible to select parameters (stand-o distance, traverse feed rate, and abrasive mass flow rate) that minimize the characteristic defects of the process such as taper angle or the identification of di erent surface quality regions in order to eliminate striations caused by jet deviation. For this purpose, taper angle and roughness evaluations were carried out in three di erent zones: initial or jet inlet, intermediate, and final or jet outlet. In this way, it was possible to characterize di erent cutting regions with scanning electronic microscopy (SEM) and to distinguish the statistical significance of the parameters and their e ects on the cut through an analysis of variance (ANOVA). This analysis has made it possible to distinguish the optimal parameters for the process.