%0 Journal Article 
%A López Castro, Juan de Dios
%A Marchal, A.
%A González Rovira, Leandro
%A Botana Pedemonte, Francisco Javier
%T Topological optimization and manufacturing by Direct Metal Laser Sintering of an aeronautical part in 15-5PH stainless steel
%D 2017
%@ 2351-9789
%U http://hdl.handle.net/10498/36520
%X DMLS (Direct Metal Laser Sintering) Additive manufacturing allows building topological optimized geometries with good mechanical properties and low weight. These features are appropriated for the aeronautical industry because the reduction of weight involves saving costs per trip. However, the manufacturing cost using SLM (Selective Laser Melting) or DMLS, is also high since titanium alloys powder is expensive. Therefore, this work aims to explore the possibility of using 15-5PH stainless steel powder to balance the mechanical properties, weight and cost of the part.
%K DMLS
%K topology optimization
%K AISI 15-5PH
%K stainless steel
%K aeronautical
%~ Universidad de Cádiz