%0 Journal Article 
%A Sanchez, Y.
%A Trujillo, F.J.
%A Sevilla, L.
%A Marcos Bárcena, Mariano
%T Indirect Monitoring Method of Tool Wear using the Analysis of Cutting Force during Dry Machining of Ti Alloys
%D 2017
%@ 2351-9789
%U http://hdl.handle.net/10498/36593
%X Tool life optimization is in constant evolution; so many researchers have focused applied different measuring techniques for the tool wear because plays a significant role in the control and improvement of product during machining operations, in real time. Titanium alloys are widely used in many industries of strategic interest as aerospace sector, in the manufacturing of parts with a good strength to weight ratio. These alloys usually show a poor machinability, due to their low thermal conductivity and modulus of elasticity, which may increase the cutting temperature and make the tool breakage more likely. This paper presents a methodology for the tool wear monitoring by using the analysis of cutting forces during dry machining of Titanium alloys.
%K Titanium alloys
%K Orthogonal cutting
%K Cutting force
%K Chip morphology
%K Wear mechanisms
%~ Universidad de Cádiz