Show simple item record

dc.contributor.authorRuiz-Garcia, Raul
dc.contributor.authorMayuet Ares, Pedro Francisco 
dc.contributor.authorVázquez Martínez, Juan Manuel 
dc.contributor.authorSalguero Gómez, Jorge 
dc.contributor.otherIngeniería Mecánica y Diseño Industrialen_US
dc.date.accessioned2019-06-19T08:54:54Z
dc.date.available2019-06-19T08:54:54Z
dc.date.issued2019-01
dc.identifier.issn1996-1944
dc.identifier.urihttp://hdl.handle.net/10498/21370
dc.description.abstractThe incorporation of plastic matrix composite materials into structural elements of the aeronautical industry requires contour machining and drilling processes along with metallic materials prior to final assembly operations. These operations are usually performed using conventional techniques, but they present problems derived from the nature of each material that avoid implementing One Shot Drilling strategies that work separately. In this work, the study focuses on the evaluation of the feasibility of AbrasiveWaterjet Machining (AWJM) as a substitute for conventional drilling for stacks formed of Carbon Fiber Reinforced Plastic (CFRP) and aluminum alloy UNS A97050 through the study of the influence of abrasive mass flow rate, traverse feed rate and water pressure in straight cuts and drills. For the evaluation of the straight cuts, Stereoscopic Optical Microscopy (SOM) and Scanning Electron Microscopy (SEM) techniques were used. In addition, the kerf taper through the proposal of a new method and the surface quality in different cutting regions were evaluated. For the study of holes, the macrogeometric deviations of roundness, cylindricity and straightness were evaluated. Thus, this experimental procedure reveals the conditions that minimize deviations, defects, and damage in straight cuts and holes obtained by AWJM.en_US
dc.formatapplication/pdfen_US
dc.language.isoengen_US
dc.publisherMDPIen_US
dc.rightsAttribution-NonCommercial-NoDerivatives 4.0 Internacional*
dc.rights.urihttp://creativecommons.org/licenses/by-nc-nd/4.0/*
dc.sourceMaterials 2019, 12, 107en_US
dc.subjectAWJMen_US
dc.subjectstacken_US
dc.subjectCFRPen_US
dc.subjectaluminum UNS A97050en_US
dc.subjectSOM/SEMen_US
dc.subjectkerf taperen_US
dc.subjectsurface qualityen_US
dc.subjectmacrogeometric deviationsen_US
dc.titleInfluence of AbrasiveWaterjet Parameters on the Cutting and Drilling of CFRP/UNS A97075 and UNS A97075/CFRP Stacksen_US
dc.typejournal articleen_US
dc.rights.accessRightsopen accessen_US
dc.identifier.doi10.3390/ma12010107


Files in this item

This item appears in the following Collection(s)

Show simple item record

Attribution-NonCommercial-NoDerivatives 4.0 Internacional
This work is under a Creative Commons License Attribution-NonCommercial-NoDerivatives 4.0 Internacional