Show simple item record

dc.contributor.authorMayuet Ares, Pedro Francisco 
dc.contributor.authorRodríguez Parada, María Lucía 
dc.contributor.authorGómez Parra, Álvaro 
dc.contributor.authorBatista Ponce, Moisés 
dc.contributor.otherIngeniería Mecánica y Diseño Industriales_ES
dc.date.accessioned2020-05-06T13:20:21Z
dc.date.available2020-05-06T13:20:21Z
dc.date.issued2020-02
dc.identifier.issn2076-3417
dc.identifier.urihttp://hdl.handle.net/10498/22877
dc.description.abstractMetal matrix composite (MMC) materials are increasingly used in industrial sectors such as energy, structural, aerospace, and automotive. This is due to the improvement of properties by the addition of reinforcements. Thus, it is possible to obtain properties of higher strength, better rigidity, controlled thermal expansion, and elevated wear resistance. However, due to the extreme hardness achieved during their manufacture, these composites pose a challenge to the conventional machining industry due to the rapid deterioration experienced by cutting tools. This article therefore proposes the use of an unconventional machining method that is becoming increasingly widely used: abrasive water jet cutting. This process is characterized by high production rates, absence of wear, and environmental friendliness, among other advantages. Experimental tests were carried out in order to analyze results that minimize the formation of defects in the machining of metal matrix composite consisting of aluminium matrix with silicon carbide (Al-SiC MMC). To this end, results were analyzed using Scanning Optical and Electron Microscope (SOM/SEM) techniques, the taper angle was calculated, and areas with different surface quality were detected by measuring the roughness.es_ES
dc.formatapplication/pdfes_ES
dc.language.isoenges_ES
dc.publisherMDPIes_ES
dc.rightsAtribución 4.0 Internacional*
dc.rights.urihttp://creativecommons.org/licenses/by/4.0/*
dc.sourceAppl. Sci. 2020, 10(4), 1512es_ES
dc.subjectAWJMes_ES
dc.subjectwaterjetes_ES
dc.subjectMMCes_ES
dc.subjectMMCA356/SiCes_ES
dc.subjectkerf taperes_ES
dc.subjecttaper anglees_ES
dc.subjectsurface qualityes_ES
dc.subjectroughnesses_ES
dc.subjectSOMes_ES
dc.subjectSEMes_ES
dc.subjectANOVAes_ES
dc.titleCharacterization and Defect Analysis of Machined Regions in Al-SiC Metal Matrix Composites Using an Abrasive Water Jet Machining Processes_ES
dc.typejournal articlees_ES
dc.rights.accessRightsopen accesses_ES
dc.identifier.doi10.3390/app10041512


Files in this item

This item appears in the following Collection(s)

Show simple item record

Atribución 4.0 Internacional
This work is under a Creative Commons License Atribución 4.0 Internacional