Show simple item record

dc.contributor.authorHammad, Ahmed
dc.contributor.authorAbdel-Nasser, Yehia
dc.contributor.authorChuriaque Bermejo, Cristina 
dc.contributor.authorSánchez Amaya, José María 
dc.contributor.otherCiencia de los Materiales e Ingeniería Metalúrgica y Química Inorgánicaes_ES
dc.date.accessioned2021-12-13T10:46:04Z
dc.date.available2021-12-13T10:46:04Z
dc.date.issued2021-09
dc.identifier.issn2075-4701
dc.identifier.urihttp://hdl.handle.net/10498/25849
dc.description.abstractThis study predicts the behavior of welded plate panels (unstiffened plates) with different geometrical properties (slenderness ratio and aspect ratio) in order to address a rational structural design procedure, as these parameters are of great importance from a structural design perspective. Nonlinear finite element analysis has been used to simulate the butt-welding process of plate panels, giving the three-dimensional distribution of distortion and residual stresses induced by welding through the design of a moving heat source. The numerical results are validated with published experimental measurements. The effect of geometrical properties such as slenderness ratio beta and aspect ratio a/b on the creation of welding-induced imperfections (distortion and residual stresses) have been investigated in this work. These geometrical properties influence the creation of the welding-induced imperfections, which in turn affect the load-carrying capacity of the plate panels. Three different plate slenderness ratios with three different aspect ratios have been studied. It is concluded that increasing the plate aspect ratio can highly increase the out-of-plane distortion magnitude as well as the compressive residual stress. The plates with high slenderness ratio (thin thicknesses) are highly affected by increasing plate aspect ratio a/b. As the slenderness ratio beta increases, the reduction in the ultimate strength due to the existence of welding-induced imperfections highly decreases. Slenderness ratio beta can highly affected the ultimate strength of plates with smaller aspect ratio more than plates with higher aspect ratio.es_ES
dc.description.sponsorshipThis research was funded by Erasmus+ Programme of European Union Commission (Erasmus+ KA107 grant), that has allowed A.H. to cover the expenses at the University of Cadizes_ES
dc.formatapplication/pdfes_ES
dc.language.isoenges_ES
dc.publisherMDPIes_ES
dc.rightsAtribución 4.0 Internacional*
dc.rights.urihttp://creativecommons.org/licenses/by/4.0/*
dc.sourceMetals 2021, 11(9), 1381es_ES
dc.subjectultimate strengthes_ES
dc.subjectbuckling collapsees_ES
dc.subjectwelding residual stresses_ES
dc.subjectdeflectiones_ES
dc.subjectFEMes_ES
dc.titleRationally-Based Structural Design of Welded Plate Panelses_ES
dc.typejournal articlees_ES
dc.rights.accessRightsopen accesses_ES
dc.identifier.doi10.3390/met11091381


Files in this item

This item appears in the following Collection(s)

Show simple item record

Atribución 4.0 Internacional
This work is under a Creative Commons License Atribución 4.0 Internacional