Mostrar el registro sencillo del ítem

dc.contributor.authorRitacco, Tiziana
dc.contributor.authorDi Cianni, Wera
dc.contributor.authorPerziano, Dario
dc.contributor.authorMagarò, Pietro
dc.contributor.authorConvertino, Annalisa
dc.contributor.authorMaletta, Carmine
dc.contributor.authorDe Luca, Antonio
dc.contributor.authorSanz de León, Alberto 
dc.contributor.authorGiocondo, Michele
dc.contributor.otherCiencia de los Materiales e Ingeniería Metalúrgica y Química Inorgánicaes_ES
dc.date.accessioned2022-06-06T11:08:14Z
dc.date.available2022-06-06T11:08:14Z
dc.date.issued2020-04
dc.identifier.isbn10.1021/acsami.1c21708
dc.identifier.issn1944-8252
dc.identifier.urihttp://hdl.handle.net/10498/26883
dc.description.abstractThis paper reports on the nanofabrication of a fiber-reinforced polymer nanocomposite (FRPN) by two-photon direct laser writing (TP-DLW) using silica nanowires (SiO2 NWs) as nanofillers, since they feature a refractive index very close to that of the photoresist used as a polymeric matrix. This allows for the best resolution offered by the TP-DLW technique, even with high loads of SiO2 NWs, up to 70 wt %. The FRPN presented an increase of approximately 4 times in Young's modulus (8.23 GPa) and nanohardness (120 MPa) when compared to those of the bare photoresist, indicating how the proposed technique is well-suited for applications with higher structural requirements. Moreover, three different printing configurations can be implemented thanks to the use of silicon chips, on which the SiO2 NWs are grown, as fabrication substrates. First, they can be effectively used as an adhesive layer when the laser beam is focused at the interface with the silicon substrate. Second, they can be used as a sacrificial layer, when the laser beam is focused in a plane inside the SiO2 NW layer. Third, only the outer shell of the object is printed so that the SiO2 NW tangle acts as the internal skeleton for the structure being fabricated in the so-called shell and scaffold printing strategy.es_ES
dc.formatapplication/pdfes_ES
dc.language.isoenges_ES
dc.publisherAMER CHEMICAL SOCes_ES
dc.rightsAtribución 4.0 Internacional*
dc.rights.urihttp://creativecommons.org/licenses/by/4.0/*
dc.sourceACS Applied Materials and Interfaces, Vol. 14, Núm. 15, pp. 17754-17762es_ES
dc.subjectdirect laser writinges_ES
dc.subjecttwo-photon absorptiones_ES
dc.subjectnanocompositeses_ES
dc.subjectnanofabricationes_ES
dc.subjectsilica nanowireses_ES
dc.subjectnanomechanicses_ES
dc.titleHigh-Resolution 3D Fabrication of Glass Fiber-Reinforced Polymer Nanocomposite (FRPN) Objects by Two-Photon Direct Laser Writinges_ES
dc.typejournal articlees_ES
dc.rights.accessRightsopen accesses_ES
dc.identifier.doi10.1021/acsami.1c21708


Ficheros en el ítem

Este ítem aparece en la(s) siguiente(s) colección(ones)

Mostrar el registro sencillo del ítem

Atribución 4.0 Internacional
Esta obra está bajo una Licencia Creative Commons Atribución 4.0 Internacional