Show simple item record

dc.contributor.authorGarcia-Lodeiro, Inés
dc.contributor.authorGonzalez-Aguza, S.
dc.contributor.authorZarzuela Sánchez, Rafael 
dc.contributor.authorPardos, Y.
dc.contributor.authorGarcia-Navarro, R.
dc.contributor.authorTebar, A.
dc.contributor.authorMosquera Díaz, María Jesús 
dc.contributor.authorBlanco-Varela, María Teresa
dc.contributor.otherQuímica Físicaes_ES
dc.date.accessioned2022-06-08T10:22:45Z
dc.date.available2022-06-08T10:22:45Z
dc.date.issued2022-05
dc.identifier.issn2352-7102
dc.identifier.urihttp://hdl.handle.net/10498/26912
dc.description.abstractCracks sealing in deteriorated concrete often requires the use of repair mortars of compatible composition, good adhesion to the substrate and free of shrinkage. Even where repair mortars properly bond to the substrate, that interface affords a preferred pathway for water ingress. Hydrophobic repair micromortars designed to seal cracks via injection might be one way to solve that problem. This article analyses the effect of adding three hydrophobic products (generic labelled as UCA-TP) comprising silica oligomers, n-octylamine (a surfactant) and polydimethylsiloxane (PDMS) in different proportions (10 wt% of PDMS :UCA-TP10, 28 wt% of PDMS: UCA-TP28 and 56 wt% of PDMS: UCA-TP56) to a fresh repair micromortar. The incorporation of UCA-TP products hastened the early hydration kinetics of repair micromortars, and, at the same time, after 7 days of hydration, declined the total heat released (the higher is the content of UCA-TP product and its proportion of PDMS the lower is the heat of hydration. The inclusion of the hydrophobic products substantially modified the repair micomortar wetting and water transport properties, by inducing a hydrophobic behavior (contact angle >100 degrees) and decreasing water absorption by >60%. Although adding those products to the repair micromortars increased porosity and lowered mechanical performance, 28 d compressive strength was consistently >50 MPa, a value that compared well to the original substrate. Simulated cracks were very effectively sealed by the repair micromortars.es_ES
dc.formatapplication/pdfes_ES
dc.language.isoenges_ES
dc.publisherELSEVIERes_ES
dc.rightsAttribution-NonCommercial-NoDerivatives 4.0 Internacional*
dc.rights.urihttp://creativecommons.org/licenses/by-nc-nd/4.0/*
dc.sourceJournal of Building Engineering, Vol. 48es_ES
dc.subjectRepair micromortares_ES
dc.subjectSilica oligomerses_ES
dc.subjectPDMSes_ES
dc.subjectPorosityes_ES
dc.subjectHydrophobicityes_ES
dc.titleStudying the dosage-dependent influence of hydrophobic alkoxysilane/siloxane admixtures on the performance of repair micromortarses_ES
dc.typejournal articlees_ES
dc.rights.accessRightsopen accesses_ES
dc.identifier.doi10.1016/j.jobe.2021.103905


Files in this item

This item appears in the following Collection(s)

Show simple item record

Attribution-NonCommercial-NoDerivatives 4.0 Internacional
This work is under a Creative Commons License Attribution-NonCommercial-NoDerivatives 4.0 Internacional