Mostrar el registro sencillo del ítem

dc.contributor.authorPérez Moreno, Antonio
dc.contributor.authorPiñero de los Ríos, Manuel 
dc.contributor.authorFernández Montesinos, Rafael 
dc.contributor.authorPinaglia Tobaruela, Gonzalo 
dc.contributor.authorReyes Peces, María Virtudes 
dc.contributor.authorMesa Díaz, María del Mar 
dc.contributor.authorVilches Pérez, José Ignacio
dc.contributor.authorEsquivia, Luis
dc.contributor.authorRosa Fox, Nicolás Daniel de la 
dc.contributor.authorSalido Peracaula, Mercedes 
dc.contributor.otherAnatomía Patológica, Biología Celular, Histología, Historia de la Ciencia, Medicina Legal y Forense y Toxicologíaes_ES
dc.contributor.otherFísica de la Materia Condensadaes_ES
dc.contributor.otherIngeniería Química y Tecnología de Alimentoses_ES
dc.date.accessioned2024-02-06T09:00:42Z
dc.date.available2024-02-06T09:00:42Z
dc.date.issued2023-05
dc.identifier.issn2310-2861
dc.identifier.urihttp://hdl.handle.net/10498/30644
dc.description.abstractChitosan (CS) is a natural biopolymer that shows promise as a biomaterial for bone-tissue regeneration. However, because of their limited ability to induce cell differentiation and high degradation rate, among other drawbacks associated with its use, the creation of CS-based biomaterials remains a problem in bone tissue engineering research. Here we aimed to reduce these disadvantages while retaining the benefits of potential CS biomaterial by combining it with silica to provide sufficient additional structural support for bone regeneration. In this work, CS-silica xerogel and aerogel hybrids with 8 wt.% CS content, designated SCS8X and SCS8A, respectively, were prepared by sol-gel method, either by direct solvent evaporation at the atmospheric pressure or by supercritical drying in CO2, respectively. As reported in previous studies, it was confirmed that both types of mesoporous materials exhibited large surface areas (821 m(2)g(-1)-858 m(2)g(-1)) and outstanding bioactivity, as well as osteoconductive properties. In addition to silica and chitosan, the inclusion of 10 wt.% of tricalcium phosphate (TCP), designated SCS8T10X, was also considered, which stimulates a fast bioactive response of the xerogel surface. The results here obtained also demonstrate that xerogels induced earlier cell differentiation than the aerogels with identical composition. In conclusion, our study shows that the sol-gel synthesis of CS-silica xerogels and aerogels enhances not only their bioactive response, but also osteoconduction and cell differentiation properties. Therefore, these new biomaterials should provide adequate secretion of the osteoid for a fast bone regenerationes_ES
dc.formatapplication/pdfes_ES
dc.language.isoenges_ES
dc.publisherMDPIes_ES
dc.sourceGels, Vol. 9, Núm. 5, 2023es_ES
dc.subjectxerogeles_ES
dc.subjectaerogeles_ES
dc.subjectchitosanes_ES
dc.subjectbioactivityes_ES
dc.subjectosteoconductiones_ES
dc.subjectfocal adhesiones_ES
dc.subjectmechanotransductiones_ES
dc.subjectbone healinges_ES
dc.titleChitosan-Silica Hybrid Biomaterials for Bone Tissue Engineering: A Comparative Study of Xerogels and Aerogelses_ES
dc.typejournal articlees_ES
dc.rights.accessRightsopen accesses_ES
dc.identifier.doi10.3390/GELS9050383
dc.type.hasVersionVoRes_ES


Ficheros en el ítem

Este ítem aparece en la(s) siguiente(s) colección(ones)

Mostrar el registro sencillo del ítem