Show simple item record

dc.contributor.authorBurgos Pintos, Pedro 
dc.contributor.authorSanz de León, Alberto 
dc.contributor.authorMolina Rubio, Sergio Ignacio 
dc.contributor.otherCiencia de los Materiales e Ingeniería Metalúrgica y Química Inorgánicaes_ES
dc.date.accessioned2024-03-02T17:27:11Z
dc.date.available2024-03-02T17:27:11Z
dc.date.issued2024
dc.identifier.issn2214-8604
dc.identifier.urihttp://hdl.handle.net/10498/31272
dc.description.abstractPolyethylene terephthalate (PET) is an engineering material widely used in packaging and cosmetics, given its excellent mechanical properties, water resistance and recyclability. PET is typically manufactured by injection blow molding but its use in additive manufacturing (AM) is not spread enough due to its (semi)crystalline behavior, which makes it difficult to process by Material Extrusion (ME) technologies. Alternatively, polyethylene terephthalate glycol copolymer (PETG), a fully amorphous material, is used in these technologies. However, PETG has worse mechanical properties than PET. In this context, this work studies the viability of different commercial PET by ME for Large Format Additive Manufacturing (LFAM). While PET for general purposes (PET1 and PET2) could not be printed, a marketable PET for thick-walled products (PET3) allowed to manufacture different objects by ME-LFAM with good dimensional accuracy. DSC and XRD studies evidenced that its slow crystallizing behavior was key to obtaining a proper flow and a successful printing. Young’s modulus and tensile strength of PET3 was significantly higher than those of PETG, both from this work and in previous reports found in the literature, since it remains semicrystalline after printing. This allows expanding the library of materials available for AM, positioning PET as a potential material for those industrial applications where PETG does not meet the necessary mechanical requirements.es_ES
dc.formatapplication/pdfes_ES
dc.language.isoenges_ES
dc.publisherElsevieres_ES
dc.sourceAdditive Manufacturing, Vol. 79es_ES
dc.subjectLarge format additive manufacturinges_ES
dc.subjectMaterial extrusiones_ES
dc.subjectPETes_ES
dc.subjectCrystallizationes_ES
dc.subjectMechanical propertieses_ES
dc.titleLarge Format Additive Manufacturing of Polyethylene terephthalate (PET) by Material Extrusiones_ES
dc.typejournal articlees_ES
dc.rights.accessRightsopen accesses_ES
dc.identifier.doi10.1016/J.ADDMA.2023.103908
dc.type.hasVersionVoRes_ES


Files in this item

This item appears in the following Collection(s)

Show simple item record