Show simple item record

dc.contributor.authorSuffo Pino, Miguel 
dc.contributor.authorLópez-Marín, C.
dc.contributor.authorRevenga, C.
dc.contributor.authorAndrés Cano, Pablo 
dc.contributor.otherIngeniería Mecánica y Diseño Industriales_ES
dc.date.accessioned2024-10-16T11:58:06Z
dc.date.available2024-10-16T11:58:06Z
dc.date.issued2024-06-13
dc.identifier.issn2590-1230
dc.identifier.urihttp://hdl.handle.net/10498/33634
dc.description.abstractCurrently, Total Hip Replacement (THR) hip prosthetics are typically made from metallic materials using subtractive manufacturing, and they are not personalized. These materials, with higher densities than trabecular bone, can cause microfractures due to fatigue cycles. This study aims to demonstrate the feasibility of using Polyetherimide (PEI) as a rigid thermoplastic in additive manufacturing, offering a viable alternative for patient- specific prostheses in humans or pets. The starting point was a commercial prosthesis, a similar replica was 3D modelled, and test specimens were printed using ULTEM 1010 material. The PEI prosthesis meets outlined standards and offers an alternative for young, lightweight patients, and various pets. It does so by adapting to specific the patient’s anatomical needs. Fatigue life was found to be the limiting factor, as the 392 N applied prosthesis, exceeded the million cycles limitation set for this study, prompting us to focus on the prosthesis’ use on children, or small pets.es_ES
dc.formatapplication/pdfes_ES
dc.language.isoenges_ES
dc.publisherElsevier B. V.es_ES
dc.rightsAttribution-NonCommercial-NoDerivatives 4.0 Internacional*
dc.rights.urihttp://creativecommons.org/licenses/by-nc-nd/4.0/*
dc.sourceResults in Engineering, Vol. 23, 2024es_ES
dc.subjectNon-metallic hip prosthesises_ES
dc.subjectFatigue life testes_ES
dc.subjectULTEM™ 1010 biomateriales_ES
dc.subjectAdditive manufacturinges_ES
dc.subjectBiomechanical designes_ES
dc.titlePolyetherimide in 3D printing: Pioneering non-metallic solutions for personalized orthopedic and traumatology hip prostheticses_ES
dc.typejournal articlees_ES
dc.rights.accessRightsopen accesses_ES
dc.identifier.doi10.1016/j.rineng.2024.102372
dc.relation.projectIDinfo:eu-repo/grantAgreement/Junta de Andalucía//TEP-181/ES/Tecnologia Del Medio Ambiente/ es_ES
dc.type.hasVersionVoRes_ES


Files in this item

This item appears in the following Collection(s)

Show simple item record

Attribution-NonCommercial-NoDerivatives 4.0 Internacional
This work is under a Creative Commons License Attribution-NonCommercial-NoDerivatives 4.0 Internacional