Show simple item record

dc.contributor.authorSol Illana, Irene del 
dc.contributor.authorGámez López, Antonio Juan 
dc.contributor.authorRivero, Asunción
dc.contributor.authorIglesias, Patricia
dc.contributor.otherIngeniería Mecánica y Diseño Industriales_ES
dc.date.accessioned2025-01-20T18:20:47Z
dc.date.available2025-01-20T18:20:47Z
dc.date.issued2019-04-10
dc.identifier.issn0043-1648
dc.identifier.urihttp://hdl.handle.net/10498/34587
dc.description.abstractDry machining of aluminum parts has been the most eco-friendly method in an attempt to reduce the use of mineral-based lubricants and other working fluids. The drawbacks of dry machining include an increase of contact temperatures and stresses leading to high values of tool wear and a decrease of the tool life. For this reason, more sustainable lubricants are needed as a middle point between waste generation and tool life. Since 2001, Ionic Liquids (ILs) have attracted interest as high-performance lubricants and lubricant additives. In this work, the lubricating ability of one halogen-containing and two halogen-free ILs used as additives in water has been investigated and compared to a halogen-containing cutting fluid (CF). Tests were performed using a pin-on-disk tribometer for aluminum-tungsten carbide pair. The worn surfaces of the disks and balls were analyzed by optical and scanning electron microscopies, non-contact 3D profilometry and energy dispersive X-ray spectroscopy. It was found that the addition of 1 wt.% of one of the halogen-free ILs reduces friction and wear of both aluminum disks and ceramic balls with respect to dry or water-lubricated conditions. In addition, no wear was detected on the ball surface, therefore increasing the tool life compared to the CF.es_ES
dc.formatapplication/pdfes_ES
dc.language.isoenges_ES
dc.publisherElsevieres_ES
dc.rightsAttribution-NonCommercial-NoDerivatives 4.0 Internacional*
dc.rights.urihttp://creativecommons.org/licenses/by-nc-nd/4.0/*
dc.sourceDel Sol, Gámez, Rivero, y Iglesias, «Tribological performance of ionic liquids as additives of water-based cutting fluids», Wear, vol. 426-427, pp. 845-852, 2019, doi: 10.1016/J.WEAR.2019.01.109es_ES
dc.subjectIonic liquidses_ES
dc.subjectcutting fluidses_ES
dc.subjectlubricationes_ES
dc.subjectaluminum-carbide contactes_ES
dc.titleTribological performance of ionic liquids as additives of water-based cutting fluidses_ES
dc.typejournal articlees_ES
dc.rights.accessRightsembargoed accesses_ES
dc.identifier.doi10.1016/J.WEAR.2019.01.109
dc.relation.projectIDinfo:eu-repo/grantAgreement/MINECO//DPI2015-71448-R/ES/ANALISIS Y EVALUACION DEL RENDIMIENTO DE TECNOLOGIAS EN EL MECANIZADO DE CONTORNOS DE FIBRA DE CARBONO/ es_ES
dc.relation.projectIDUCA/REC01VI/2016es_ES
dc.relation.projectIDUCA/ R20REC/2017es_ES
dc.type.hasVersionSMURes_ES


Files in this item

This item appears in the following Collection(s)

Show simple item record

Attribution-NonCommercial-NoDerivatives 4.0 Internacional
This work is under a Creative Commons License Attribution-NonCommercial-NoDerivatives 4.0 Internacional