Mostrar el registro sencillo del ítem

dc.contributor.authorSambruno Ladrón de Guevara, Alejandro 
dc.contributor.authorBañón García, Fermín 
dc.contributor.authorSalguero Gómez, Jorge 
dc.contributor.authorSimonet, Bartolomé
dc.contributor.authorBatista Ponce, Moisés 
dc.contributor.otherIngeniería Mecánica y Diseño Industriales_ES
dc.date.accessioned2025-01-29T07:09:33Z
dc.date.available2025-01-29T07:09:33Z
dc.date.issued2021-04-05
dc.identifier.issn0268-3768
dc.identifier.urihttp://hdl.handle.net/10498/34977
dc.description.abstractThe application of carbon fiber reinforced thermoplastic matrix composites (CFRTP) is constantly increasing in various industrial sectors due to their mechanical properties and advantages compared to thermoset matrix composite. Nevertheless, CFRTP machining generates a current problem due to the anisotropy of these materials, the difficulty of impregnation of the reinforcement in the matrix, and its low melting temperature. For this reason, the study of conventional operations such as milling to achieve geometries with a good surface quality and reduced cosmetic defects is a line of research of great interest. In this article, a comparison of five cutting tools with different geometries has been made in CFRTP milling. The surface quality and the formation of visual defects such as fiber pull-out have been evaluated for each tool and combination of cutting parameters. In this sense, 16.42 μm in terms of Rz is the minimum average value for the complete experiment obtained for a conventional tool (tool A). However, surface qualities in terms of Rz close to 20 μm and minimum cosmetic defects have been obtained with a hybrid tool (tool C) with −10° helix angle and 8 teeth with a combination of cutting parameters of 0.07 mm/tooth and 3000 rpm, being the most complete tool of the experiment.es_ES
dc.formatapplication/pdfes_ES
dc.language.isoenges_ES
dc.publisherSpringeres_ES
dc.rightsAttribution-NonCommercial-NoDerivatives 4.0 Internacional*
dc.rights.urihttp://creativecommons.org/licenses/by-nc-nd/4.0/*
dc.sourceInternational Journal of Advanced Manufacturing Technology, Vol. 114, Núm. 7-8, 2021, pp. 2515-2526es_ES
dc.subjectMillinges_ES
dc.subjectCFRTPes_ES
dc.subjectSurface Qualityes_ES
dc.subjectRzes_ES
dc.subjectFiber pull-outes_ES
dc.subjectC/TPUes_ES
dc.titleStudy of milling of low thickness thermoplastic carbon fiber composites in function of tool geometry and cutting conditionses_ES
dc.typejournal articlees_ES
dc.rights.accessRightsclosed accesses_ES
dc.identifier.doi10.1007/s00170-021-07050-1
dc.type.hasVersionVoRes_ES


Ficheros en el ítem

Este ítem aparece en la(s) siguiente(s) colección(ones)

Mostrar el registro sencillo del ítem

Attribution-NonCommercial-NoDerivatives 4.0 Internacional
Esta obra está bajo una Licencia Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 Internacional