Show simple item record

dc.contributor.authorSambruno Ladrón de Guevara, Alejandro 
dc.contributor.authorGómez Parra, Álvaro 
dc.contributor.authorMárquez, Pablo
dc.contributor.authorTellaeche-Herrera, Iñaki
dc.contributor.authorBatista Ponce, Moisés 
dc.contributor.otherIngeniería Mecánica y Diseño Industriales_ES
dc.date.accessioned2025-03-10T11:03:29Z
dc.date.available2025-03-10T11:03:29Z
dc.date.issued2024
dc.identifier.issn2079-6439
dc.identifier.urihttp://hdl.handle.net/10498/35783
dc.description.abstractThe use of carbon fiber reinforced polymers (CFRP) is crucial in industries, such as aerospace, automotive, and marine, due to their excellent strength-to-weight ratio and corrosion resistance. However, machining CFRP is challenging due to its abrasive nature, which can cause premature tool wear. Some of the commonly used processes for machining these materials are dry milling and abrasive water jet machining (AWJM), which offer the best alternatives from an environmental point of view. This article presents an analysis of the defects and surface quality obtained in CFRP after machining by AWJM and milling. For this purpose, combinations of relevant parameters have been chosen for each process: cutting speed and tool wear in milling and traverse feed rate and hydraulic pressure in AWJM. The results obtained have been evaluated from two points of view: macroscopically, through the evaluation of delamination, and microscopically, through the study of the roughness in terms of Ra. Furthermore, a discussion on functional, environmental, economic, and social terms has been made between both processes. In summary, each machining process generates a specific type of delamination: Type II in milling and Type I in AWJM. In addition, the best Ra results are obtained for pressures of 1200 bar in AWJM.es_ES
dc.formatapplication/pdfes_ES
dc.language.isoenges_ES
dc.publisherMultidisciplinary Digital Publishing Institute (MDPI)es_ES
dc.rightsAtribución 4.0 Internacional*
dc.rights.urihttp://creativecommons.org/licenses/by/4.0/*
dc.sourceFibers - 2024, Vol. 12 n. 10, artículo n. 78es_ES
dc.subjectAWJMes_ES
dc.subjectCFRPes_ES
dc.subjectdelaminationes_ES
dc.subjectmillinges_ES
dc.subjectsurface qualityes_ES
dc.titleEvaluation of Peripheral Milling and Abrasive Water Jet Cutting in CFRP Manufacturing: Analysis of Defects and Surface Qualityes_ES
dc.typejournal articlees_ES
dc.rights.accessRightsopen accesses_ES
dc.identifier.doi10.3390/fib12100078
dc.type.hasVersionVoRes_ES


Files in this item

This item appears in the following Collection(s)

Show simple item record

Atribución 4.0 Internacional
This work is under a Creative Commons License Atribución 4.0 Internacional