Show simple item record

dc.contributor.authorNúñez, A.
dc.contributor.authorCOLLADO GARCIA, IRENE
dc.contributor.authorMuratori, M.
dc.contributor.authorRuiz, A.
dc.contributor.authorAlmagro, J.F.
dc.contributor.authorSales Lérida, David 
dc.contributor.otherCiencia de los Materiales e Ingeniería Metalúrgica y Química Inorgánicaes_ES
dc.date.accessioned2025-11-10T07:18:58Z
dc.date.available2025-11-10T07:18:58Z
dc.date.issued2025
dc.identifier.issn2504-4494
dc.identifier.urihttp://hdl.handle.net/10498/37852
dc.description.abstractThis study investigates the hot deformation behaviour and microstructural evolution of two AISI 430 ferritic stainless steel variants: 0A (basic) and 1C (modified). These variants primarily differ in chemical composition, with 0A containing higher austenite-stabilizing elements (C, N) compared to 1C, which features lower interstitial content and slightly higher Si and Cr. This research aimed to optimize hot rolling conditions for enhanced forming properties. Uniaxial hot compression tests were conducted using a Gleeble thermo-mechanical system between 850 and 990 °C at a strain rate of 3.3 s−1, simulating industrial finishing mill conditions. Analysis of flow curves, coupled with detailed microstructural characterization using electron backscatter diffraction, revealed distinct dynamic restoration mechanisms influencing each material’s response. Thermodynamic simulations confirmed significant austenite formation in both materials within the tested temperature range, notably affecting their deformation behaviour despite their initial ferritic state. Material 0A consistently exhibited a strong tendency towards dynamic recrystallization (DRX) across a wider temperature range, particularly at 850 °C. DRX led to a microstructure with a high concentration of low-angle grain boundaries and sharp deformation textures, actively reorienting grains towards energetically favourable configurations. However, under this condition, DRX did not fully complete the recrystallization process. In contrast, material 1C showed greater activity of both dynamic recovery and DRX, leading to a much more advanced state of grain refinement and recrystallization compared to 0A. This indicates that the composition of 1C helps mitigate the strong influence of the deformation temperature on the crystallographic texture, leading to a weaker texture overall than 0A.es_ES
dc.formatapplication/pdfes_ES
dc.language.isoenges_ES
dc.publisherMultidisciplinary Digital Publishing Institute (MDPI)es_ES
dc.rightsAtribución 4.0 Internacional*
dc.rights.urihttp://creativecommons.org/licenses/by/4.0/*
dc.sourceJournal of Manufacturing and Materials Processing, Vol. 9 n. 8, 265es_ES
dc.subjectFSSes_ES
dc.subjecthot deformationes_ES
dc.subjectDRXes_ES
dc.subjectDRVes_ES
dc.subjectLAGBses_ES
dc.subjectcrystallographic texture;es_ES
dc.subjectEBSDes_ES
dc.subjectGleeble simulationes_ES
dc.titleInfluence of Alpha/Gamma-Stabilizing Elements on the Hot Deformation Behaviour of Ferritic Stainless Steeles_ES
dc.typejournal articlees_ES
dc.rights.accessRightsopen accesses_ES
dc.identifier.doi10.3390/jmmp9080265
dc.type.hasVersionVoRes_ES


Files in this item

This item appears in the following Collection(s)

Show simple item record

Atribución 4.0 Internacional
This work is under a Creative Commons License Atribución 4.0 Internacional