Ball milling preparation and the effect of calcination temperature on the photocatalytic performance of titanium dioxide

Identificadores
URI: http://hdl.handle.net/10498/38175
DOI: 10.1016/J.OCERAM.2025.100791
ISSN: 2666-5395
Statistics
Metrics and citations
Metadata
Show full item recordDate
2025-05-01Department
Química FísicaSource
Open Ceramics - 2025, Vol. 22, artículo n. 100791Abstract
The present study investigates the preparation of LiF-doped TiO2 powders using the ball milling technique, with a focus on optimizing dispersion parameters and assessing the impact of calcination temperature on their photocatalytic activity. TiO2 powders doped with 2 wt. % LiF were prepared using an industrial attrition mill (Dyno-Mill®) and subjected to heat treatments at different temperatures to control the anatase-to-rutile phase transition. Characterization techniques, including X-ray diffraction (XRD), Brunauer-Emmett-Teller (BET) surface area analysis, thermogravimetric analysis (TGA), and UV–Vis spectroscopy using the diffuse reflectance mode (DRS), were employed to evaluate phase composition, surface properties, and optical band gap variations. The photocatalytic performance was assessed through the degradation of methylene blue (MB) under UV–Vis irradiation. The results revealed that the anatase-to-rutile transformation occurred at 700 °C, with a mixed anatase-rutile phase exhibiting enhanced photocatalytic activity. Despite a low BET surface area, the sample calcined at 700 °C for 30 min demonstrated the highest MB degradation rate, outperforming commercial TiO2 (P25). The improved efficiency is attributed to the synergistic effects between anatase and rutile phases of TiO2. This study highlights the potential of ball milling as a scalable method for tailoring TiO2-based photocatalysts with optimized phase composition and photocatalytic properties.
Subjects
Anatase-rutile transition; Ball milling; LiF doping; Methylene blue degradation; Photocatalysis; TiO2Collections
- Artículos Científicos [12059]






