Show simple item record

dc.contributor.authorBarboza Neto, E.S.
dc.contributor.authorChludzinski, Mariane 
dc.contributor.authorRoese, P.B.
dc.contributor.authorFonseca, J.S.O.
dc.contributor.authorAmico, S.C.
dc.contributor.authorFerreira, C.A.
dc.contributor.otherCiencia de los Materiales e Ingeniería Metalúrgica y Química Inorgánicaes_ES
dc.date.accessioned2026-02-23T15:15:20Z
dc.date.available2026-02-23T15:15:20Z
dc.date.issued2011
dc.identifier.issn0142-9418
dc.identifier.urihttp://hdl.handle.net/10498/38841
dc.description.abstractThis work investigates the behavior under burst pressure testing of a pressure vessel liner. The liner was produced with a polymer blend of 95 wt.% low linear density polyethylene (LLDPE) and 5 wt.% of high density polyethylene (HDPE). The liner is to be used in an all– composite carbon/epoxy compressed natural gas (CNG) shell, manufactured by the fila- ment winding process, with variable composite thickness. Experimental hydrostatic tests were conducted on reduced scale and actual liner models. Design and failure prediction of the composite laminate shell and the polymeric liner were conducted based on Tsai-Wu and von Mises criteria, respectively, using commercial Finite Element Analysis (FEA) software. Simulation and testing were both important in order to define adequate production parameters for the polymeric liner so that it could be successfully used in a composite pressure vessel.es_ES
dc.formatapplication/pdfes_ES
dc.language.isoenges_ES
dc.publisherElsevieres_ES
dc.sourcePolymer Testing, Vol. 30, Núm. 6, 2011, pp. 693-700es_ES
dc.titleExperimental and numerical analysis of a LLDPE/HDPE liner for a composite pressure vesseles_ES
dc.typejournal articlees_ES
dc.rights.accessRightsopen accesses_ES
dc.identifier.doi10.1016/j.polymertesting.2011.04.016
dc.type.hasVersionVoRes_ES


Files in this item

This item appears in the following Collection(s)

Show simple item record