Show simple item record

dc.contributor.authorDiz Mellado, Eduardo María 
dc.contributor.authorJiménez Guerrero, Adriana
dc.contributor.authorPérez Fenoy, José
dc.contributor.authorRivera Gómez, Carlos
dc.contributor.authorGalán Marín, Carmen
dc.contributor.otherMáquinas y Motores Térmicoses_ES
dc.date.accessioned2026-04-21T10:04:49Z
dc.date.available2026-04-21T10:04:49Z
dc.date.issued2025-12
dc.identifier.issn2214-5095
dc.identifier.urihttp://hdl.handle.net/10498/39329
dc.description.abstractThis study focuses on optimizing the 3D printability through Liquid Deposition Modelling (LDM) of ceramic clays, particularly addressing the challenges of processing low-moisture mixtures. The main objective was to assess how the chemical and physical composition of clays, along with some deflocculant additive, affects their performance during 3D printing. The plasticity and other properties of different types of clay were evaluated. The results showed that clays with higher plasticity, like White, allowed for easier printing with lower pressures, while Red clay, with lower plasticity, required Sodium Silicate to enhance printability at reduced moisture levels. The addition of deflocculates improved the fluidity of the clay, facilitating smoother extrusion without needing higher pressure. However, the study highlighted that reducing water content significantly could not be fully offset by additives, underscoring the importance of maintaining a balanced moisture level. In conclusion, the controlled use of additives and precise regulation of printing conditions greatly improved the efficiency and quality of 3D printing. This research contributes to advancements in ceramic additive manufacturing, offering important insights for improving material handling and print quality in clay-based 3D printing applications.es_ES
dc.formatapplication/pdfes_ES
dc.language.isoenges_ES
dc.publisherElsevieres_ES
dc.rightsAttribution-NonCommercial-NoDerivatives 4.0 Internacional*
dc.rights.urihttp://creativecommons.org/licenses/by-nc-nd/4.0/*
dc.sourceCase Studies in Construction Materials-2025, Vol. 23, e05377es_ES
dc.subject3D Printinges_ES
dc.subjectClayes_ES
dc.subjectPrintabilityes_ES
dc.subjectCeramices_ES
dc.subjectAdditive Manufacturinges_ES
dc.titleParameter-based optimization of the 3D clay-printabilityes_ES
dc.typejournal articlees_ES
dc.rights.accessRightsopen accesses_ES
dc.identifier.doi10.1016/J.CSCM.2025.E05377
dc.relation.projectIDinfo:eu-repo/grantAgreement/AEI/JDC2023–050478-Ies_ES
dc.relation.projectIDinfo:eu-repo/grantAgreement/Junta de Andalucía. Consejería de Universidad, Investigación e Innovación/T22CCTT_00009es_ES
dc.type.hasVersionVoRes_ES


Files in this item

This item appears in the following Collection(s)

Show simple item record

Attribution-NonCommercial-NoDerivatives 4.0 Internacional
This work is under a Creative Commons License Attribution-NonCommercial-NoDerivatives 4.0 Internacional