RT journal article T1 Study of the surface quality of carbon fiber–reinforced thermoplastic matrix composite (CFRTP) machined by abrasive water jet (AWJM) A1 Bañón García, Fermín A1 Sambruno Ladrón de Guevara, Alejandro A1 Batista Ponce, Moisés A1 Simonet, Bartolomé A1 Salguero Gómez, Jorge A2 Ingeniería Mecánica y Diseño Industrial K1 AWJM K1 CFRTP K1 Surface quality K1 RSM K1 ANOVA K1 C/TPU AB Carbon fiber-reinforced thermoplastics (CFRTP) have great interest nowadays due to their excellent mechanical properties andlightness. However, in opposition to thermoset matrix composites, there is a lake in the research about machining processes ofthese materials. Their low glass transition temperature is a handicap when conventional machining is used. An alternative isabrasive water jet machining (AWJM) because it does not cause thermal damage. However, the surface quality produced by thisprocess must be studied and related to the cutting parameters. This article studies the surface quality generated by water jetmachining in a low melting point thermoplastic matrix composite material. The kind of thermoplastic used is a TPU (polyurethane).The combination of a high-strength material (carbon fiber) with a low-strength material (thermoplastic matrix) makesmachining difficult and can generate a poor surface finish. The influence of cutting parameters has been evaluated through anANOVA analysis. A mathematical model that relates the surface quality with the cutting parameters has been established bymeans of a response surface methodology (RSM). The combination of a hydraulic pressure of 250 MPa with a traverse speed of300 mm/min and an abrasive mass flow of 170 g/min produces the best surface quality. Finally, the main flaws when CFRTP iswater jet machined have also been identified. PB Springer SN 1433-301 YR 2020 FD 2020-03-13 LK http://hdl.handle.net/10498/34976 UL http://hdl.handle.net/10498/34976 LA eng DS Repositorio Institucional de la Universidad de Cádiz RD 16-nov-2026