RT journal article T1 Study of milling of low thickness thermoplastic carbon fiber composites in function of tool geometry and cutting conditions A1 Sambruno Ladrón de Guevara, Alejandro A1 Bañón García, Fermín A1 Salguero Gómez, Jorge A1 Simonet, Bartolomé A1 Batista Ponce, Moisés A2 Ingeniería Mecánica y Diseño Industrial K1 Milling K1 CFRTP K1 Surface Quality K1 Rz K1 Fiber pull-out K1 C/TPU AB The application of carbon fiber reinforced thermoplastic matrix composites (CFRTP) is constantly increasing in various industrialsectors due to their mechanical properties and advantages compared to thermoset matrix composite. Nevertheless, CFRTPmachining generates a current problem due to the anisotropy of these materials, the difficulty of impregnation of the reinforcementin the matrix, and its low melting temperature. For this reason, the study of conventional operations such as milling toachieve geometries with a good surface quality and reduced cosmetic defects is a line of research of great interest. In this article, acomparison of five cutting tools with different geometries has been made in CFRTP milling. The surface quality and theformation of visual defects such as fiber pull-out have been evaluated for each tool and combination of cutting parameters. Inthis sense, 16.42 μm in terms of Rz is the minimum average value for the complete experiment obtained for a conventional tool(tool A). However, surface qualities in terms of Rz close to 20 μm and minimum cosmetic defects have been obtained with ahybrid tool (tool C) with −10° helix angle and 8 teeth with a combination of cutting parameters of 0.07 mm/tooth and 3000 rpm,being the most complete tool of the experiment. PB Springer SN 0268-3768 YR 2021 FD 2021-04-05 LK http://hdl.handle.net/10498/34977 UL http://hdl.handle.net/10498/34977 LA eng DS Repositorio Institucional de la Universidad de Cádiz RD 16-nov-2026