RT conference output
T1 Indirect Monitoring Method of Tool Wear using the Analysis of Cutting Force during Dry Machining of Ti Alloys
A1 Sanchez, Y.
A1 Trujillo, F.J.
A1 Sevilla, L.
A1 Marcos Bárcena, Mariano
A2 Ingeniería Mecánica y Diseño Industrial
K1 Titanium alloys
K1 Orthogonal cutting
K1 Cutting force
K1 Chip morphology
K1 Wear mechanisms
AB Tool life optimization is in constant evolution; so many researchers have focused applied different measuring techniques for the tool wear because plays a significant role in the control and improvement of product during machining operations, in real time. Titanium alloys are widely used in many industries of strategic interest as aerospace sector, in the manufacturing of parts with a good strength to weight ratio. These alloys usually show a poor machinability, due to their low thermal conductivity and modulus of elasticity, which may increase the cutting temperature and make the tool breakage more likely. This paper presents a methodology for the tool wear monitoring by using the analysis of cutting forces during dry machining of Titanium alloys.
PB Elsevier
SN 2351-9789
YR 2017
FD 2017
LK http://hdl.handle.net/10498/36593
UL http://hdl.handle.net/10498/36593
LA eng
DS Repositorio Institucional de la Universidad de Cádiz
RD 07-nov-2026