• español
    • English
  • Login
  • español 
    • español
    • English

UniversidaddeCádiz

Área de Biblioteca, Archivo y Publicaciones
Comunidades y colecciones
Ver ítem 
  •   RODIN Principal
  • Producción Científica
  • Artículos Científicos
  • Ver ítem
  •   RODIN Principal
  • Producción Científica
  • Artículos Científicos
  • Ver ítem
JavaScript is disabled for your browser. Some features of this site may not work without it.

Development and validation of a sampling and analysis method to determine biogenic sulfur in a desulfurization bioreactor by gas chromatography coupled with a pulsed flame photometric detector (GC-PFPD).

Thumbnail
Identificadores

URI: http://hdl.handle.net/10498/25885

DOI: 10.1016/j.jhazmat.2021.127667

ISSN: 1873-3336

Ficheros
APC_2021_068.pdf (1.422Mb)
Estadísticas
Ver estadísticas
Métricas y Citas
 
Compartir
Exportar a
Exportar a MendeleyRefworksEndNoteBibTexRIS
Metadatos
Mostrar el registro completo del ítem
Autor/es
Torres Herrera, SandraAutoridad UCA; González Cortés, José JoaquínAutoridad UCA; Almengló Cordero, FernandoAutoridad UCA; Ramírez Muñoz, MartínAutoridad UCA; Cantero Moreno, DomingoAutoridad UCA
Fecha
2022-02
Departamento/s
Ingeniería Química y Tecnología de Alimentos
Fuente
Journal of Hazardous Materials 424 (2022) 127667
Resumen
Suspended biomass bioreactors can be operated to remove H2S from biogas under anoxic conditions and produce elemental sulfur, the commercial value of which has been demonstrated. In the present paper, a novel methodology comprising the optimization of a determination method performed in a gas chromatograph equipped with a pulsed flame photometric detector (GC-PFPD), combined with a simple preparation based on filtration and extraction with toluene, is proposed. The injector temperature and carrier gas flow rate (QHe) values were optimized using a response surface methodology based on a face-centred composite central design. This optimization revealed that the optimum conditions were an injector temperature and carrier gas flow rate of 222°C and 7mLmin-1, respectively. The chromatographic method shows an analysis time of 48min, a detection limit of more than 5.9mgL-1, a relative standard deviation of less than 3.71%, and a sulfur recovery percentage of more than 98%. These values provide excellent linearity and a reasonable concentration range (10-200mgL-1). Finally, a measurement error of 4.45% was obtained when using the present method in a selectivity test. Copyright © 2021 The Authors. Published by Elsevier B.V. All rights reserved.
Materias
Biogenic sulfur; GC-PFPD; Toluene; Filtration; Response surface methodology (RSM)
Colecciones
  • Artículos Científicos [12034]
  • Articulos Científicos Ing. Quim. [314]
  • Artículos Científicos IVAGRO [736]
Attribution-NonCommercial-NoDerivatives 4.0 Internacional
Esta obra está bajo una Licencia Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 Internacional

Listar

Todo RODINComunidades y ColeccionesPor fecha de publicaciónAutoresTítulosMateriasEsta colecciónPor fecha de publicaciónAutoresTítulosMaterias

Mi cuenta

AccederRegistro

Estadísticas

Ver Estadísticas de uso

Información adicional

Acerca de...Deposita en RODINPolíticasNormativasDerechos de autorEnlaces de interésEstadísticasNovedadesPreguntas frecuentes

RODIN está accesible a través de

OpenAIREOAIsterRecolectaHispanaEuropeanaBaseDARTOATDGoogle Académico

Enlaces de interés

Sherpa/RomeoDulcineaROAROpenDOARCreative CommonsORCID

RODIN está gestionado por el Área de Biblioteca, Archivo y Publicaciones de la Universidad de Cádiz

ContactoSugerenciasAtención al Usuario