• español
    • English
  • Login
  • español 
    • español
    • English

UniversidaddeCádiz

Área de Biblioteca, Archivo y Publicaciones
Comunidades y colecciones
Ver ítem 
  •   RODIN Principal
  • Producción Científica
  • Artículos Científicos
  • Ver ítem
  •   RODIN Principal
  • Producción Científica
  • Artículos Científicos
  • Ver ítem
JavaScript is disabled for your browser. Some features of this site may not work without it.

Occurrence, identification and removal of microplastics in a wastewater treatment plant compared to an advanced MBR technology: Full-scale pilot plant

Thumbnail
Identificadores

URI: http://hdl.handle.net/10498/28750

DOI: 10.1016/j.jece.2023.109644

ISSN: 2213-3437

Ficheros
APC_2023_040.htm (174.5Kb)
Estadísticas
Ver estadísticas
Métricas y Citas
 
Compartir
Exportar a
Exportar a MendeleyRefworksEndNoteBibTexRIS
Metadatos
Mostrar el registro completo del ítem
Autor/es
Egea-Corbacho Lopera, AgataAutoridad UCA; Martín García, Ana PilarAutoridad UCA; Franco del Pino, Ana AmeliaAutoridad UCA; Quiroga Alonso, José MaríaAutoridad UCA; Andreasen, Rune Røjgaard; Jørgensen, Mads Koustrup; Christensen, Morten Lykkegaard
Fecha
2023-03-10
Departamento/s
Tecnologías del Medio Ambiente
Fuente
Journal of Environmental Chemical Engineering Vol. 11, n. 3 (2023) 109644
Resumen
Microplastics are of increasing interest as one of the most important threats to the natural environment and aquatic life. One of the main pathways of microplastics entering the aquatic and terrestrial environment are wastewater treatment plants. The aim of this study was to investigate the occurrence and removal of MPs in both wastewater and sludge from an MBR-based and a WWTP. The focus is on the amount of microplastics emitted into the environment, the efficiency of removal in wastewater treatment plants and how their operation and design, could be improved to reduce the presence of these pollutants in the effluent. The results showed that the influent (SI) had mean concentration of 507 ± 70 MPs L-1, in the reactor tank (SRS) the concentration increases to 1.77 × 107 ± 1.61 × 107 MPs kg-1 (dw) and in the permeate (SP) the estimated amount of microplastics decreased to 1.58 ± 1.08 MPs L-1. This is a removal efficiency of 99.69%, with respect to the estimated average MPs. After the clarifier (SC) and sand filtration (SSF) a mean of 17.38 ± 4.71 MPs L-1 and 2.93 ± 1.50 MPs L-1 respectively were found, resulting in an efficiency of 96.58% and 99.42%, respectively, regarding the inlet water of the treatment plant. The two predominant forms in all samples (except for SCS) were fragments and fibers. In total 25 types of polymers were detected, and only 5 resulted in all types of samples, the most detected polymer families were Acrylates and Polyethylenes.
Materias
Microplastics; Membrane bioreactor (MBR); Wastewater Treatment Plant; Sludge
Colecciones
  • Artículos Científicos [12059]
  • Artículos Científicos INMAR [1048]
  • Articulos Científicos Tec. Med. Amb. [215]
Attribution-NonCommercial-NoDerivatives 4.0 Internacional
Esta obra está bajo una Licencia Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 Internacional

Listar

Todo RODINComunidades y ColeccionesPor fecha de publicaciónAutoresTítulosMateriasEsta colecciónPor fecha de publicaciónAutoresTítulosMaterias

Mi cuenta

AccederRegistro

Estadísticas

Ver Estadísticas de uso

Información adicional

Acerca de...Deposita en RODINPolíticasNormativasDerechos de autorEnlaces de interésEstadísticasNovedadesPreguntas frecuentes

RODIN está accesible a través de

OpenAIREOAIsterRecolectaHispanaEuropeanaBaseDARTOATDGoogle Académico

Enlaces de interés

Sherpa/RomeoDulcineaROAROpenDOARCreative CommonsORCID

RODIN está gestionado por el Área de Biblioteca, Archivo y Publicaciones de la Universidad de Cádiz

ContactoSugerenciasAtención al Usuario