Topological optimization and manufacturing by Direct Metal Laser Sintering of an aeronautical part in 15-5PH stainless steel

Identificadores
URI: http://hdl.handle.net/10498/36520
DOI: 10.1016/J.PROMFG.2017.09.121
ISSN: 2351-9789
Ficheros
Estadísticas
Métricas y Citas
Metadatos
Mostrar el registro completo del ítemFecha
2017Departamento/s
Ciencia de los Materiales e Ingeniería Metalúrgica y Química Inorgánica; Ingeniería Mecánica y Diseño IndustrialFuente
Procedia Manufacturing - 2017, Vol. 13 pp. 818-824Resumen
DMLS (Direct Metal Laser Sintering) Additive manufacturing allows building topological optimized geometries with good mechanical properties and low weight. These features are appropriated for the aeronautical industry because the reduction of weight involves saving costs per trip. However, the manufacturing cost using SLM (Selective Laser Melting) or DMLS, is also high since titanium alloys powder is expensive. Therefore, this work aims to explore the possibility of using 15-5PH stainless steel powder to balance the mechanical properties, weight and cost of the part.






